Start the BootROM
After the device is powered on, it runs the BootROM software to initialize the hardware and display the hardware parameters. Then the device runs the system software.

To check the BootROM startup process, you need to connect the Console port of the switch to a terminal by using a serial cable.
The BootROM compares the current configuration with the configuration file. If they are the same, the BootROM asks you whether to reboot the system. The message is as follows:
Info: The system is now comparing the configuration, please wait.
System will reboot! Continue?[Y/N]:y
BIOS LOADING ...
Copyright (c) 2008-2010 HUAWEI TECH CO., LTD.
CX22EFFE (Ver124, Jun 9 2010, 17:41:46)
Press Ctrl+B to enter BOOTROM menu ... 0
Press Ctrl+B within 2 seconds. The system prompts you to enter the password of the advanced BootROM menu as follows:
The default password is Admin@huawei.com.

This password can be reset to Admin@huawei.com by using the
reset boot password command in the system view. After resetting the password, restart the device. When the message "Press Enter to get started:" is displayed, wait for 3 seconds and press
Enter to make the reset password take effect.
password:
BOOTROM MENU
1. Boot with default mode
2. Enter serial submenu
3. Enter startup submenu
4. Enter ethernet submenu
5. Enter filesystem submenu
6. Modify BOOTROM password
8. Reboot
а затем
BOOTROM MENU
2. Enter serial submenu
3. Enter startup submenu
4. Enter ethernet submenu
5. Enter filesystem submenu
6. Modify BOOTROM password
7. Clear password for console user
8. Reboot
In the advanced BootROM menu, you can choose to upgrade the system software or specify the system software version to be loaded when the device is started.

In the BootROM menu, you can enter Ctrl+e to enter the hidden view. In the hidden view, some device test functions are provided for production, assembly, and factory repair.
The BootROM initializes the serial interface and the console interface, decompresses the logical files on the logical chip and the system software, and starts the system software. The terminal displays information as follows:
Decompressing Image file ... done
PPI DEV SysInit......OK
Hard system init.................OK
Begin to start the system, please waiting ......
VOS VFS init.....................OK
VOS monitor init.................OK
CFM init advance.................OK
PAT init ........................OK
VOS VFS init hind ...............OK
VRP_Root begin...
VRP_InitializeTask begin...
Init the Device Link.............OK
CFG_PlaneInit begin..............OK
CFM_Init begin...................OK
CLI_CmdInit begin................OK
VRP_RegestAllLINKCmd begin.......OK
create task begin................
task init begin...
Recover configuration...OK!done
Press ENTER to get started.
When the message "Press ENTER to get started." is displayed, the system software has started. Press Enter to enter the command line interface (CLI).

Information display varies depending on device models.