A través del análisis del logbuffer, se determina cuando es un problema con el módulo óptico. En este caso, el problema ocurrió en dos ocasiones:
Nov 7 2018 05:52:05+03:00 y Nov 8 2018 06:03:36+03:00, por lo que se determina que hay un problema en el módulo Gig 0/1/1.
Para analizar el problema es recomendable revisarlo conectado directamente en la red.
Los logs encontrados son:
#Nov 7 2018 05:52:05+03:00 PO-RMNS-USVLDRK-SW-PE-1 SRM/3/SFP_EXCEPTION:OID 1.3.6.1.4.1.2011.5.25.129.2.1.9 Optical module exception, SFP is not certified. (EntityPhysicalIndex=67125326, BaseTrapSeverity=5, BaseTrapProbableCause=136192, BaseTrapEventType=9, EntPhysicalContainedIn=67125261, EntPhysicalName=GigabitEthernet0/1/1, RelativeResource=Interface GigabitEthernet0/1/1 optical module exception, ReasonDescription=It has been observed that a transceiver has been installed that is not certified by Huawei Ethernet Switch. Huawei cannot ensure that it is completely adaptive and will not cause any adverse effects. If it is continued to be used, Huawei is not obligated to provide support to remedy defects or faults arising out of or resulting from installing and using of the non-certified transceiver. )
Y
#Nov 8 2018 06:03:36+03:00 PO-RMNS-USVLDRK-SW-PE-1 SRM/3/SFP_EXCEPTION:OID 1.3.6.1.4.1.2011.5.25.129.2.1.9 Optical module exception, SFP is not certified. (EntityPhysicalIndex=67125326, BaseTrapSeverity=5, BaseTrapProbableCause=136192, BaseTrapEventType=9, EntPhysicalContainedIn=67125261, EntPhysicalName=GigabitEthernet0/1/1, RelativeResource=Interface GigabitEthernet0/1/1 optical module exception, ReasonDescription=It has been observed that a transceiver has been installed that is not certified by Huawei Ethernet Switch. Huawei cannot ensure that it is completely adaptive and will not cause any adverse effects. If it is continued to be used, Huawei is not obligated to provide support to remedy defects or faults arising out of or resulting from installing and using of the non-certified transceiver. )
Esto nos habla de que, en efecto hay un problema con el módulo óptico.
En este caso, hay que revisar el transceiver y lo mejor es hacerlo a través de un acceso a la red.
