Why Is the Multicast Source Register Message Still Forwarded After the register-policy Command Is Configured on the RP to Discard the Register Message

Created: May 12, 2017 00:48:26Latest reply: May 15, 2017 00:26:35 691 1 0 0 0

Why Is the Multicast Source Register Message Still Forwarded After the register-policy Command Is Configured on the RP to Discard the Register Message?

x
convention：
Emotion(0)

Like (0) Dislike (0) Favorite(0) Report

 Previous: How to Enable an RP Router to Filter the Received Multicast Data Packets Based on the Source Address or Source/Group Address?

Next: How to Perform Load Balancing When the Outbound Interface of Multicast Traffic Is an Eth-Trunk Interface or an IP-Trunk Interface?



(0) (0)

^2#

Adamcolob Created May 15, 2017 00:26:35

This command should be configured in proper time. If the RPT has been switched to be the SPT when the register-policy command is being configured, packet forwarding is only based on the SPT. After the register-policy command is configured, the multicast source register message is filtered out and the RPT entry is aged. The SPT entry, however, still exists. Thus, packets can still be forwarded.

x
convention：

Comment

Notice: To protect the legitimate rights and interests of you, the community, and third parties, do not release content that may bring legal risks to all parties, including but are not limited to the following:

Politically sensitive content
Content concerning pornography, gambling, and drug abuse
Content that may disclose or infringe upon others ' commercial secrets, intellectual properties, including trade marks, copyrights, and patents, and personal privacy

Do not share your account and password with others. All operations performed using your account will be regarded as your own actions and all consequences arising therefrom will be borne by you. For details, see " User Agreement."

My Followers

Are you sure to block this user?
Users on your blacklist cannot comment on your post,cannot mention you, cannot send you private messages.

Please bind your phone number to obtain invitation bonus.

Enterprise

Consumer

Corporate

Carriers

Why Is the Multicast Source Register Message Still Forwarded After the register-policy Command Is Configured on the RP to Discard the Register Message

Third Party’s Trade Secret

My Followers