|
Fixed Switches
Huawei fixed switches support only one type of copper transceiver module: SFP-1000BaseT, a GE copper transceiver module that has been certified by Huawei.
Table 1 describes the fixed switches' support for copper transceiver modules.
Table 1 Fixed switches' support for copper transceiver modules
Series
|
Support for GE Copper Transceiver Module
|
---|
S2700
|
Not supported
|
S2750
|
Supported on all optical interfaces except the combo optical interfaces
|
S3700
|
Not supported
|
S5700-LI
|
Supported on all optical interfaces except the combo optical interfaces, in V200R002C00 and later versions
|
S5700S-LI
|
Supported on all optical interfaces, in V200R002C00 and later versions
|
S5700-SI
|
Supported on all optical interfaces except the combo optical interfaces
NOTE:
10GE interface cards are supported in V200R002C00 and later versions.
When interfaces on a GE interface card use GE copper transceiver modules, the interfaces can go Up, but the commands used for configuring the interface speed, duplex mode, auto-negotiation, MDI, flow control, and virtual cable test cannot be used on the interfaces.
|
S5700-EI
|
Supported on all optical interfaces except the combo optical interfaces and interfaces on 10GE interface cards
NOTE:
When interfaces on a GE interface card use GE copper transceiver modules, the interfaces can go Up, but the commands used for configuring the interface speed, duplex mode, auto-negotiation, MDI, flow control, and virtual cable test cannot be used on the interfaces.
|
S5700-HI
|
Supported on all optical interfaces
NOTE:
10GE interface cards are supported in V200R002C00 and later versions.
When interfaces on a GE interface card use GE copper transceiver modules, the interfaces can go Up, but the commands used for configuring the interface speed, duplex mode, auto-negotiation, MDI, flow control, and virtual cable test cannot be used on the interfaces.
|
S5710-LI
|
Supported on GE interface cards
NOTE:
When interfaces on a GE interface card use GE copper transceiver modules, the interfaces can go Up, but the commands used for configuring the interface speed, duplex mode, auto-negotiation, MDI, flow control, and virtual cable test cannot be used on the interfaces.
|
S5710-EI
|
Supported on all 10GE optical interfaces, in V200R002C00 and later versions
|
S5710-HI
|
Supported on fixed 10GE optical interfaces on the panel
|
S5720-EI
|
Supported on all optical interfaces except the combo optical interfaces and interfaces on 10GE interface cards
|
S5720-SI
|
Supported on all optical interfaces except the combo optical interfaces
|
S5720S-SI
|
Supported on all optical interfaces
|
S5720-HI
|
Supported on fixed 10GE optical interfaces on the panel
|
S6700
|
Supported on all optical interfaces, in V200R001C01 and later versions
|
Modular Switches
None of combo optical interfaces supports GE copper transceiver modules.
Optical interfaces on GE optical interfaces cards support copper transceiver modules.
On a 10GE interface card, the 10GE interfaces that can work in GE mode support GE copper transceiver modules.
The preceding support information applies to copper transceiver modules that have been certified by Huawei. When non-Huawei-certified copper transceiver modules are installed on interfaces of Huawei switches, the interfaces still work as optical interfaces.
|
|
|