Which of the following are the methods to add WLAN devices on eSight?

A. Add resource manually
B. Automatically discovery
D. Importing devices in batches


============
Adding devices is the basis for resource management. You can add devices to eSight in either of the following ways:
 Automatically discovering devices
eSight supports multiple protocols for automatic discovery and discovery modes. You can configure discovery tasks and uniformly manage the tasks. Four automatic discovery modes are available.
Discovery by IP segment: eSight uses SNMP to discover devices in specified network segments and adds them. This mode is simple.
Discovery by IP segment: eSight uses SNMP or other protocols to discover devices in specified network segments and adds them. This mode is complex.
ARP-based discovery: eSight searches manageable network devices based on their ARP entries.
Route-based discovery: eSight searches manageable network devices based on the routing table.
 Manually adding a single device
Through SNMP: Enter the IP address of a device and set its SNMP parameters to add the device to eSight.
 Manually importing devices in a batch
Through SNMP: Add devices to eSight in a batch by importing a device list that contains the device IP addresses and SNMP parameters. You can add online and offline devices.

Hi, friend!

The answer is ABCD