What Is the Default IFG on a Switch? Is the IFG Configurable?

Created: Mar 15, 2016 03:24:36Latest reply: Mar 15, 2016 09:07:15 1237 1 0 0

display all floors ^#1

x
convention：

Helpful (0) Favorite(0) Report

 Previous: How Do I Configure Aggregated CAR on the S7700 and S9700

Next: How Do I Restore the Default Factory Settings?



jack_6 Created Mar 15, 2016 09:07:15

Two Ethernet frames must have an interframe gap (IFG) to differentiate two data packets. A device uses the IFG to process a data frame after receiving it and prepares for the receiving of the next data frame. The default IFG on a switch is 12 bytes. You are advised not to change the IFG on an interface, otherwise, packet loss may occur when the interface forwards packets.

You can run the ifg ifg-value command to configure the IFG between Ethernet frames.

Only S5300-X-LI support the IFG.

For the S2300, the ifg command changes the IFG on all the interfaces.

x
convention：

Comment

Notice: To protect the legitimate rights and interests of you, the community, and third parties, do not release content that may bring legal risks to all parties, including but are not limited to the following:

Politically sensitive content
Content concerning pornography, gambling, and drug abuse
Content that may disclose or infringe upon others ' commercial secrets, intellectual properties, including trade marks, copyrights, and patents, and personal privacy

Do not share your account and password with others. All operations performed using your account will be regarded as your own actions and all consequences arising therefrom will be borne by you. For details, see " Privacy."

What Is the Default IFG on a Switch? Is the IFG Configurable?

Third Party’s Trade Secret

My Followers

Enterprise

Consumer

Corporate

Carriers

What Is the Default IFG on a Switch? Is the IFG Configurable?

Third Party’s Trade Secret

My Followers