VRRP Master/Backup Switchover
Created: Dec 30, 2019 12:03:22Latest reply: Dec 30, 2019 12:03:45
352
1
0
0
0
Rewarded HiCoins：
0
(problem resolved)
Hello, everyone.
As shown in the networking diagram, two S6700 switches set up a stack and set up an Eth-Trunk. VRRP is enabled in the VLAN to which the Eth-Trunk belongs. After the two switches are powered off in sequence, it takes 5 minutes for the peer device to become the master device in the VRRP group. Why five minutes? Can anyone explain? Thank you.
- x
- convention：
- Emotion(0)
Comment
Notice: To protect the legitimate rights and interests of you, the community, and third parties, do not release content that may bring legal risks to all parties, including but are not limited to the following:
- Politically sensitive content
- Content concerning pornography, gambling, and drug abuse
- Content that may disclose or infringe upon others ' commercial secrets, intellectual properties, including trade marks, copyrights, and patents, and personal privacy
