VLL support on S7700

Enterprise

Community Forums Switches

Created: Dec 11, 2014 10:55:58Latest reply: Dec 12, 2014 01:27:38 1494 1 0 0

Hi,

I want to configure Kompella VLL using S7700 switches. When I use VLAN encapsulation everything works (port link-type trunk on PE on both sides).

The problem is that I have VLAN encapsulation on one side (port link-type trunk) and link-type access port on remote.

The VLL connection is up, but there is no communication. Is this config supported, or what else should be configured?

Regards,

Krzysztof

x
convention：

Helpful (0) Favorite(0) Report

Busy_with_lazy_mind Created Dec 12, 2014 01:27:38

when you connect the trunk port to access port, only two kinds of packets can get through the access port.

1. VLan tagged packet with the tag number the same as the access vlan number.

2. untagged packet.

Any other tagged packet can't get thruough the access port.

When packets go out from the trunk port, all the packets are tagged except the packet from the native vlan.

I'm not quite sure why you configure the peer port as access mode, maybe you can describe you demands, and we'll find some solution for you.

x
convention：

Comment

Notice: To protect the legitimate rights and interests of you, the community, and third parties, do not release content that may bring legal risks to all parties, including but are not limited to the following:

Politically sensitive content
Content concerning pornography, gambling, and drug abuse
Content that may disclose or infringe upon others ' commercial secrets, intellectual properties, including trade marks, copyrights, and patents, and personal privacy

Do not share your account and password with others. All operations performed using your account will be regarded as your own actions and all consequences arising therefrom will be borne by you. For details, see " Privacy."

Enterprise

Consumer

Corporate

Carriers

Third Party’s Trade Secret