VLANs on OLT with VLANs on Router Mikrotik

Hi,
Please wait patiently.

I can't see the attachment because it's still being scanned.

MA5608T#display version
{ <cr>|backplane<K>|frameid/slotid<S><Length 1-15> }:

  Command:

          display version

  VERSION : MA5600V800R015C00
  PATCH   : SPC108 HP1019
  PRODUCT : MA5608T

  Active Mainboard Running Area Information:

  --------------------------------------------------
  Current Program Area : Area A
  Current Data Area : Area A

  Program Area A Version : MA5600V800R015C00
  Program Area B Version : MA5600V800R015C00

  Data Area A Version : MA5600V800R015C00
  Data Area B Version : MA5600V800R015C00

Hi,

By analyzing the network topology:

It is recommended that no switch be connected to the ONT.

Only one terminal can be used for PPPoE dialup in bridged mode. As a result, PCs connected to the switch cannot go online at the same time.

If the ONT is set to the routing mode, the PCs connected to the ONT share the same bandwidth, which also causes network instability.

Thanks!

hello，

    you can change the Application Scenario to below:

1. ONT(bridge)+HGW +PCs

2. ONT(bridge)+PC

3. ONT(gateway)+PCs

thanks.

Hello, friend!

If the PC and switch connected to each ONT share the same VLAN, this solution is not feasible.
If the network runs normally, you need to configure a VLAN on each PC and map the VLAN to the service VLAN issued by the OLT to the ONT. 

One more question:
The bandwidth of the OLT PON port is limited. The ONT-switch-PC networking leads to insufficient network bandwidth.

As Len_non said.

The OLT can be connected to the following network scenarios:

1. ONT(bridge)+HGW +PCs

2. ONT(bridge)+PC

3. ONT(gateway)+PCs

The forum deals with live network problems more, which is of no practical significance to solution design and suggestions.

Thanks!

Thats all configuration want to change

dba-profile add profile-id 10 profile-name "dba-profile_10" type3 assure 8000 max 32000

ont-srvprofile gpon profile-id 1 profile-name "srv-profile_1" 

ont-port pots adaptive eth adaptive

 port vlan eth 1 translation 1 user-vlan 1

 port vlan eth 2 translation 1 user-vlan 1 

 port vlan eth 3 translation 1 user-vlan 1 

 port vlan eth 4 translation 1 user-vlan 1

ont-lineprofile gpon profile-id 1 profile-name "line-profile_1"  tcont 1 dba-profile-id 10

 gem add 1 eth tcont 1 

 gem mapping 1 0 vlan 1

[vlan-config] 

<vlan-config>

vlan 2 to 4 smart

port vlan 2 0/3 1

port vlan 3 0/3 2

port vlan 4 0/3 3

ont add 0 0 sn-auth "xxx" omci ont-lineprofile-id 1 ont-srvprofile-id 1 desc "ont1"

ont add 0 1 sn-auth "xxx" omci ont-lineprofile-id 1 ont-srvprofile-id 1 desc "ont2"

ont add 0 2 sn-auth "xxx" omci ont-lineprofile-id 1 ont-srvprofile-id 1 desc "ont3"

service-port 0 vlan 1 gpon 0/0/1 ont 3 gemport 1 multi-service user-vlan 1 tag-transform translate

service-port 1 vlan 1 gpon 0/0/3 ont 0 gemport 1 multi-service user-vlan 1 tag-transform translate

service-port 2 vlan 1 gpon 0/0/3 ont 2 gemport 1 multi-service user-vlan 1 tag-transform translate