VCN-3000 IPForget

MA3 · Created Jul 27, 2018 18:43:55

issue solved:)

gululu · Created Jul 28, 2018 06:48:36

Posted by MA3 at 2018-07-27 18:43 issue solved

thanks for your support!
welcome to share your method，thanks！

MA3 · Created Jul 28, 2018 10:41:16

I used Wireshark to get the unkown IP.
Step1
Power off the device,
Step 2
Connect the network cable directly with the VCN to the port where IP was configured.(this method is for any IP Device e.g IPCamera, Router, Switch etc). In my case it was port eth1 of VCN.
Step3
Start capturing the packets on your LAN interface from Wireshark while device was power off(Disable all other interface e.g Wi-Fi, Bluetooth, etc)
Step4
Power on the device (in my case its VCN).
Step5:
Under the Destination Address Tab observe the GARP(Gratious) ARP packet. The unknown IP Address was advertise by GARP. (https://wiki.wireshark.org/Gratuitous_ARP)
Step6:
Change your system IP address/subnet to the VCN IP subnet in order to reconfigure the IP.

MA3 · Created Jul 28, 2018 10:41:30

I used Wireshark to get the unkown IP.
Step1
Power off the device,
Step 2
Connect the network cable directly with the VCN to the port where IP was configured.(this method is for any IP Device e.g IPCamera, Router, Switch etc). In my case it was port eth1 of VCN.
Step3
Start capturing the packets on your LAN interface from Wireshark while device was power off(Disable all other interface e.g Wi-Fi, Bluetooth, etc)
Step4
Power on the device (in my case its VCN).
Step5:
Under the Destination Address Tab observe the GARP(Gratious) ARP packet. The unknown IP Address was advertise by GARP. (https://wiki.wireshark.org/Gratuitous_ARP)
Step6:
Change your system IP address/subnet to the VCN IP subnet in order to reconfigure the IP.

MA3 · Created Jul 28, 2018 10:42:36

I used Wireshark to get the unkown IP.
Step1
Power off the device,
Step 2
Connect the network cable directly with the VCN to the port where IP was configured.(this method is for any IP Device e.g IPCamera, Router, Switch etc). In my case it was port eth1 of VCN.
Step3
Start capturing the packets on your LAN interface from Wireshark while device was power off(Disable all other interface e.g Wi-Fi, Bluetooth, etc)
Step4
Power on the device (in my case its VCN).
Step5:
Under the Destination Address Tab observe the GARP(Gratious) ARP packet. The unknown IP Address was advertise by GARP. (https://wiki.wireshark.org/Gratuitous_ARP)
Step6:
Change your system IP address/subnet to the VCN IP subnet in order to reconfigure the IP.

KarimUC · Created Jul 29, 2018 09:59:25

good experience to share

VCN-3000 IPForget

Third Party’s Trade Secret

`@trans`bright_future`~trans`

`@trans`drinking_poetry`~trans`

My Followers

Enterprise

Consumer

Corporate

Carriers

VCN-3000 IPForget

Third Party’s Trade Secret

`@trans`bright_future`~trans`

`@trans`drinking_poetry`~trans`

My Followers