Hi,
I am trying to assign IP address on a L3 interface on S5700. Before converting interface to L3, it was a switch-port. I gave "undo portswitch" command and it executed successfully. But now I cannot assign IP address to physical interface. Is this some kind of bug? Any help will be much appreciated.
Note: I can already use SVIs (Switched Virtual Interfaces) to simulate routed interface but it is not desired here.
Regards,
indrapal
Unable to Assign IP Address to L3 Interface on S5700
Created: May 3, 2015 13:09:44Latest reply: May 26, 2015 12:01:26
1848
3
0
0
0
- x
- convention：
|
|
|
|
|
|
|
|
Comment
Notice: To protect the legitimate rights and interests of you, the community, and third parties, do not release content that may bring legal risks to all parties, including but are not limited to the following:
- Politically sensitive content
- Content concerning pornography, gambling, and drug abuse
- Content that may disclose or infringe upon others ' commercial secrets, intellectual properties, including trade marks, copyrights, and patents, and personal privacy
