If UltraPath is used, configure the active-active load balancing mode on the host. The procedure is as follows:
UltraPath CLI #1 >set hypermetro
[loadbalancemode=?] [split_size=?] [workingmode=?]
UltraPath CLI #1 >set hypermetro workingmode=
[workingmode=?] The workingmode is a string(priority|balance), default is priority.
UltraPath CLI #1 >set hypermetro workingmode=balance primary_array_id=
[primary_array_id=?] The primary_array_id is an integer(0-16383).
UltraPath CLI #1 >set hypermetro workingmode=balance primary_array_id=0
Succeeded in executing the command.
UltraPath CLI #2 >
UltraPath CLI #2 >
UltraPath CLI #2 >set hypermetro
[loadbalancemode=?] [split_size=?] [workingmode=?]
UltraPath CLI #2 >set hypermetro loadbalancemode=
[loadbalancemode=?] The loadbalance mode is a string(split-size|round-robin), default is split-size.
UltraPath CLI #2 >set hypermetro loadbalancemode=
[loadbalancemode=?] The loadbalance mode is a string(split-size|round-robin), default is split-size.
UltraPath CLI #2 >set hypermetro loadbalancemode=round-robin
[vlun_id=?]
Command is executable now.
UltraPath CLI #2 >set hypermetro loadbalancemode=round-robin
Succeeded in executing the command.
