The terminal shows that the terminal has not joined any group

Hi dear,
If a terminal shows that the terminal has not joined any group, you need to check the below configuration:

1. Check whether NEs are configured with correct licenses.
2. Check whether the eNodeB has been configured to work in the trunking mode.
3. Check whether the terminal has joined any group in the terminal registration information.

Hope it will be useful to you.
Best regards!

Hello,
To analyze the problem, perform the following operations:
1. Check whether NEs are configured with correct licenses.
2. Check the terminal registration information and verify whether the terminal has joined the desired group.
3. Check whether the eNodeB is in trunking mode by running the command LST ENODEBMODE.
Thanks