The ONT cannot be automatically discovered on the OLT.

4am · Created Dec 29, 2018 01:04:02

You can run the display ont info by-sn 485754437D87xxxx command. Check whether the current SN is configured on another port.

GongXiaochuan · Created Dec 29, 2018 00:56:35

This post was last edited by GongXiaochuan at 2018-12-29 01:21. you can using below command to enable the ont auto-find

port ont-auto-find

Function

This command is used to enable or disable the ONT auto-find function of a PON port. In general,
if an ONT is added using the ont confirm(gpon) or ont confirm(epon) command,
you must enable the ONT auto-find function. After the ONT auto-find function is enabled,
the OLT periodically checks whether there are new online ONTs. If any ONT accesses the network,
the SN (for a GPON ONT) or the MAC address (for an EPON ONT) of the ONT is
reported to the OLT. Then, you can confirm the ONT according to the reported ONT information.

http://support.huawei.com/hedex/hdx.do?lib=EDOC100014704431189675&docid=EDOC1000147044&lang=en&v=04&tocLib=EDOC100014704431189675&tocV=04&id=GUID04058B01-ACAC-4067-BE3B-4181D8357330_1&tocURL=resources/cmd/port_ont-auto-find.html&p=t&fe=1&ui=3&keyword=auto&keyword=ont&keyword=port&keyword=find&text=port+ont-auto-find

4am · Created Dec 29, 2018 01:04:02

You can run the display ont info by-sn 485754437D87xxxx command. Check whether the current SN is configured on another port.

hookl2000 · Created Dec 29, 2018 01:59:02

Posted by GongXiaochuan at 2018-12-29 00:56 you can using below command to enable the ont auto-find port ont-auto-findFunctionThis command is us ...

Thank you