The method for fixing panorama position of the VPT300

Hi, all!

Good day to you!

This post is about a method for fixing the panorama position of the VPT300.

1. Log in to the TEX0 web interface. Choose Device Control > Device Control and set Video Source to the video source of the VPT300 so that the VPT300 video is displayed on the monitor.

   
   

   

   
   

2. Choose Device Control > Camera parameters adjustment, set Voice tracking mode to Manual, and set Camera input interface to the input interface of the VPT300.

   

   
   

3. Use the SSH tool to connect to VPT300. The default user name and password are admin/Change_Me.

4. Adjust the right camera first: Run the mnt FullviewPosition set 2 command on the CLI. (2: right PTZ camera; 3: left PTZ camera)

5. Set IR to LOCAL for the camera.

   

   
   

6. Use the remote control to adjust the right VPC300 to a proper position.

7. Run the mnt FullviewPosition save 2 command on the CLI to save the configuration.

8. Set IR to REMOTE.

9. Repeat steps 4 to 8 to set the left camera, the parameter should change  to 3.

10. Run the mnt FullviewWithAutoFeame set 0 command on the CLI to set the panoramic mode.

11. On the web interface of the terminal, choose Device Control > camera parameter adjustment, select the input source corresponding to the VPT300, and set Voice tracking mode to Auto (Excluding Autoframe).

This is all, thanks for reading!