The ISM and the alarm generation time is later than the current SVP time

Hi Lucas,

The time on the SVP is different from that on the disk array.

You can resolve this problem by performing the following operations:

1. Log in to the disk array using PuTTY, and check the time on the disk array on the CLI.

It is recommended that the PuTTY of the latest version be used, because an earlier version may cause login failures.

2. On the T3000, you can view the current SVP time on the lower right corner.

3. Compare the time. It is found that the time zone of the disk array is not GMT+8, but the time zone of the SVP is GMT+8. Therefore, the time on the disk array needs to be modified.

4. Run the change system timezone Asia Beijing command on the CLI.

5. Check whether the time on the SVP is the same as that on the disk array.

Thank you.