Switch Quidway S5700-28C-HI refuses to accept ip address command on g0/0/1 interface

chenhui · Created Aug 19, 2019 00:28:51

Posted by Kiewit at 2019-08-16 14:19I'm using eNSP V100R003C00SPC100. Please see the image in the post, because I used the undo portswit ...

Hi!

In the case of S5700 in eNSP, it cannot be assigned an IP address for the physical interface. The vlanif interface should be adopted.

In the case of some AR routers, a few LAN interfaces cannot be assigned IP addresses.

DDSN · Created Aug 16, 2019 14:10:45

Dear user,

You can use display version to view the version of the S5700 switch on eNSP.

In the case of the S5700 switch, in V200R005C00 and later versions, after you run the undo portswitch command on an interface to switch the Ethernet interface from Layer 2 mode to Layer 3 mode, the interface can be configured with an IP address.

DDSN · Created Aug 16, 2019 14:10:45

Dear user,

You can use display version to view the version of the S5700 switch on eNSP.

In the case of the S5700 switch, in V200R005C00 and later versions, after you run the undo portswitch command on an interface to switch the Ethernet interface from Layer 2 mode to Layer 3 mode, the interface can be configured with an IP address.

Kiewit · Created Aug 16, 2019 14:19:15

I'm using eNSP V100R003C00SPC100. Please see the image in the post, because I used the undo portswitch command and the interface does not accept the ip address command.

DDSN · Created Aug 16, 2019 15:05:40

Posted by Kiewit at 2019-08-16 14:19 I'm using eNSP V100R003C00SPC100. Please see the image in the post, because I used the undo portswit ...

I mean checking the version of the S5700 switch, not the version of eNSP.

Kiewit · Created Aug 16, 2019 20:12:47

I checked the version of the switch, and its in the title of the post. I checked the version using the "display version" command. Do you mean the VRP version? It's "Software Version : VRP (R) Software, Version 3.30 (V200R001C00)"

chenhui · Created Aug 19, 2019 00:28:51

Posted by Kiewit at 2019-08-16 14:19I'm using eNSP V100R003C00SPC100. Please see the image in the post, because I used the undo portswit ...

Hi!

In the case of S5700 in eNSP, it cannot be assigned an IP address for the physical interface. The vlanif interface should be adopted.

In the case of some AR routers, a few LAN interfaces cannot be assigned IP addresses.

Switch Quidway S5700-28C-HI refuses to accept ip address command on g0/0/1 interface

Best answer

Recommended answer

Third Party’s Trade Secret

My Followers

Enterprise

Consumer

Corporate

Carriers

Switch Quidway S5700-28C-HI refuses to accept ip address command on g0/0/1 interface

Best answer

Recommended answer

Third Party’s Trade Secret

My Followers