Hello everyone, I would like to share Steps to Configure the New Version of GTMU through SMT.
1. Open The ETH Port Of GTMU:
SET BTSLOCALETHPORT:IDTYPE=BYNAME,BTSNAME="0000",MPSWITCH=ENABLE;
2. Get Site IP and BTSVLAN
§ BTS &BSC IP
LST BTSIP:IDTYPE=BYNAME,BTSNAME="0000";
§ BTS Next Hope
LST BTSIPRT:IDTYPE=BYNAME,BTSNAME="0000";
§ BTSVLAN
LST BTSVLAN:IDTYPE=BYNAME,BTSNAME="0000";
§ BTS Mask : 255.255.255.252
§ BSC Mask: 255.255.255.248
§ Router Mask: 255.255.255.255
Procedure In Site
2. then double-click IP over FE Static IP in the Function area.
3. Confirm the static IP network, and click OK.
4. The Static IP dialog box is displayed.
5. Click the Config BTS, BSC, and VLAN tab. On the Config tab page, set BTS and BSC port IP addresses and other related parameters
6. Click the Config Port IP tab. On the Config tab page, a set parameter related to port IP addresses Config Port IP
7. Query Port IP
Ø IF you found any wrong data (BTS IP & Mask & Board Location)
Click the Delete tab. On the Delete tab page, set parameters related to the port IP address to be deleted
8. Click the Config Route tab. On the Config tab page, set parameters for configuring routes
9. Query Static Route
Ø IF you found any wrong data (IP & Mask & Board Location)
Click the Delete tab. On the Delete tab page, set parameters for deleting routes
10. Choose Reset Site Hierarchically, Reset LeveL (third level Reset ), Reset Port ( Not select )
Thanks
