Some questions about AP5030DN

Hello, friend.
It's nice to meet you in the community.
We're working on your problem. Please wait for a second.

1. how to save from system mode
in Cisco I can type "do wr me" in config mode directly.

====== You need switch to user view and execute command save to save the configuration. There is no command that allows the administrators to execute command in the wrong view.

4. lacp in ge0/0/0 and ge0/0/1
can I increase bandwidth by bonding both ge ports?
both GE ports will be connected to AC6005

====== Yes, you can create an eth-trunk interface, and bound these two interfaces to the eth-trunk to improve the bandwidth. If your AP5030DN is work in FAT mode, you can refer to Configuring Link Aggregation in Manual Load Balancing Mode, and if it works in FIT mode, please refer to Configuring Link Aggregation on an AP's Wired Interface.

Maybe feature request in the next version
1. how to save from system mode
need extra effort to switch back and forth between user to sys mode
why I can click Save in GUI?
why Cisco Forti Juniper can do while you can't do
2. how to save without prompting
easier in scripting if I just simply put -y
3. when I save then press Enter in "(y/n)[n]:"
same as #2 easier in scripting if I don't have to type n

nowadays admin to be smarter. I just need to run netmiko or ansible in central location instead of running every command in each switch

Hi,
If you just want to autosave in the script, you can just add character y at the bottom of you script, for example:

int g0/0/0
ip add 10.1.1.1 24
q
q
save
y
dis ip in b

The script above will autosave the configuration and output the modification.