We can remote monitoring inverters by Smartlogger 3000A.
It has two ethernet input , LAN and WAN. Up to 80 inverter can connect cloud via Smartlogger 3000A.
We can connect weather station and powermeter to the smartlogger.
We can set Smartlogger 3000A both by computer or cell phone.
Smartlogger has to two communication way for inverters these are RS485 cable and Mbus Protocolle.
Also Smartlogger 3000A can work with static ıp sim card or ethernet cable.
Smartlogger's WAN port's IP adress is, 192.168.0.10 and LAN port's IP adress is 192.168.8.10
Before start comissioning , we should check those;
First, we need to check inverters correct communication(RS485 or Mbus). If connection wiil be by Mbus, the rated power of the PV system connected to Mbus port on the SmartLogger must be greater than 75KW.
Second , If we use sim card we need to remove pin code and check the ethernet connection. If internet connection will be on ethernet cable , we need to know IP adress which modem give to this ethernet cable and be sure there is internet connection on this cable.
When we start comissioning;
First we connect our computer to SmartLogger by ethernet cable via LAN port.
We change PC's Lan port's IP adress to 192.168.8.11 because otherwise they will cross with each other.
Establish internet connection for SmartLoger via WAN port , then we enter Enspire interface on web browser by entering https//:192.168.8.10 .
Smartlogger's setting has done by Enspire interface.
Firstly we search and find our devices at maintenance section if inverters' connection via RS485 or Mbus protocole have done correctly.
When we can not find inverters , we should check communications beetween inverters and smartlogger.
We enter IP adress which modem's gave to Smartlogger on settings and wired network.
At management part we enter our servers ip address and port numbers and check if it is connected.
If there is no connection we should check our connection again. When connection is correct , we will create a new plant and we will enter the smartloger serial number on NetEco management system, and then we should create a new user for account. For this, we should select system and user management section and then we will select the create user sectioni in this page we will enter the username, password, email and account level, after all we should select plant.
Now we are ready to watch our PV plant remotely.
