The ODU power attributes define the transmit power and receive power of the ODU.
Prerequisites
- You must be an NM user with NE operator authority or higher.
- The IF boards and the ODUs to which the IF boards are connected must be added on the NE Panel.
Tools, Equipment, and Materials
U2000
Procedure
- Select the ODU from the Object Tree in the NE Explorer. Choose from the Function Tree.
- Click the Power Attributes tab.
- Set the parameters of ODU power attributes.
NOTE:
- Maximum Transmit Power(dBm) is set according to the network plan. This parameter cannot be set to a value that exceeds the nominal power rang of the ODU in the guaranteed capacity modulation module.
- The maximum transmit power adjusted by using the ATPC function should not exceed Maximum Transmit Power(dBm).
- Transmit Power(dBm) is set according to the network plan. This parameter specifies the transmit power of the ODU. This parameter cannot be set to a value that exceeds the nominal power rang of the ODU or a value that exceeds Maximum Transmit Power(dBm).
- Power to Be Received(dBm) is used to set the expected receive power of the ODU and is mainly used in the antenna alignment stage. After this parameter is set, the NE automatically enables the antenna misalignment indicating function.
- Power to Be Received(dBm) is set according to the network plan. When this parameter takes the default value, the antenna misalignment indicating function is disabled.
- TX High Threshold(dBm) and TX Low Threshold(dBm) are valid only when the ATPC function is enabled.
