Results: Found related users 0, related groups 0, related topics 241, related cases 14, related FAQ 58
-
【Knowledge Base】 COM_EXTECC_FULL alarm analysis on OSN 1800
There is the COM_EXTECC_FULL alarm on OSN 1800 device.
2022-01-20 Knowledge Base
-
【Knowledge Base】 TMB1LTX is not recognized in the OSN 1800 Compact II
Was reported once add the TMB1LTX in the Optix OSN 1800 II in the slot 4...There is no abnormality in the TMB1LTX, NCE-T V100R019C00SPC60 doesn't support this board...
2021-09-13 Knowledge Base
-
【Knowledge Base】 An OptiX OSN 1800 Slave Subrack Is Unreachable During the Change of a Slave Subrack to a Master Subrack
An OptiX OSN 1800 II NE on a township WDM NE of a carrier consists of subracks 0 and 1....An OptiX OSN 8800 and OptiX OSN 1800 are connected to the unreachable...
2021-07-01 Knowledge Base
-
【Knowledge Base】 Cannot add TMB1EGS4 board in the OSN 1800V by iManager U2000 LCT
Cannot create the TMB1EGS4 board in the OSN 1800 V, using iManager U2000 LCT....The U2000 LCT R18 cannot support the current OSN 1800 R19C10 version,...
2021-08-24 Knowledge Base
-
【Knowledge Base】 V.24 9.6kbps service not through
Alarm Information No Alarm Handling Process In this case, V.24 goes to OSN 1800 ...Setting in SCADA: Setting in OSN 1800 for DXM port service In this case...
2021-12-14 Knowledge Base
-
【Knowledge Base】 cant Create Virtual STM64 on UNQ2
cant Create Virtual STM64 on UNQ2 As confirmed that on OSN 1800 the UNQ2...And on the E6608 insert into slot-5/6 it’s can support only 1*STM-64 if insert into slot...
2021-08-10 Knowledge Base
-
【Knowledge Base】 Boards in the Z5SCC Subrack Report BD_STATUS Alarms Due to Incorrect Detection of 2K Signals on the SCC Board
Multiple Boards on the OptiX OSN 1800 Report the BD_STATUS Alarm at the Same Time Due to a known software defect, the active and standby SCC boards in the slave subrack...
2021-07-01 Knowledge Base
-
【Knowledge Base】 Laser Module Mismatch Alarm on LDCA Board
This board is installed in OSN 8800.
2022-03-21 Knowledge Base
-
【Knowledge Base】 The OSC Monitoring Optical Fiber Is Unavailable for a New Install Service
Two OptiX OSN 1800V equipments are deployed and ST2+FIU optical supervisory signals are used.
2021-07-01 Knowledge Base
-
【Knowledge Base】 OTN network M40V Unflat Channels Caused by Excessive Board Insertion Loss handles
On an OTN network of a carrier, some line boards on the local node and downstream nodes report IN-PWR-LOW alarms.A and B are core hub nodes and CDEF are convergence nodes. 1.Multiple...
2021-07-01 Knowledge Base
Filter by Time
Did not find what you were looking for?
Search on support.huawei.com
Users on your blacklist cannot comment on your post,cannot mention you, cannot send you private messages.