This post was last edited by yoface at 2018-06-29 15:37.
Hello
I activated the port security mode for all my gigabit ports 0/0/1 - 0/0/24 with port security enable
I let all it all on standard configuration. The Standard config says with port security the port will only learn 1 MAC adress and when a second new one is connected it will restrict it.
When I test it with two different notebooks, both notebooks can communicate over the same port althoug port security is enabled on this port.
Why does the port not restrict the second Notebook? Is there a other option needed too?
The last question is for me, how can I configure the switch it will sending a message to my snmp client if a unintentional event is happening on a port so I get alert? Is that possible with configuring traps?
Notice: To protect the legitimate rights and interests of you, the community, and third parties, do not release content that may bring legal risks to all parties, including but are not limited to the following:
Politically sensitive content
Content concerning pornography, gambling, and drug abuse
Content that may disclose or infringe upon others ' commercial secrets, intellectual properties, including trade marks, copyrights, and patents, and personal privacy
Do not share your account and password with others. All operations performed using your account will be regarded as your own actions and all consequences arising therefrom will be borne by you. For details, see " User Agreement."