RTN

Dear xamare
There are many methods, you can watch the alarm, you can collect performance data for analysis！

Thank you!

Thanks, how can I collect data performance ?

Hello,
For interference, The troubleshooting procedure is as follows:

1-Check whether there is co-channel interference.

a-Mute the ODU at the opposite end.
b-Check the RSL at the local end. If the RSL exceeds -90 dBm, it indicates that there is co-channel interference that may affect the long-term availability and performance of the system.
2-Check whether there is adjacent channel interference.

a-Mute the ODU at the opposite end.
b-Adjust the microwave working mode at the local end and use the minimum channel spacing.
c-Decrease the receive frequency at the local end by a half of the channel spacing.
d-Test and record the RSL.
e-Increase the receive frequency at the local end, with a step of 0.5 MHz or 1 MHz. Record the RSL accordingly until the receive frequency is equal to the original receive frequency plus a half of the channel spacing.
f-Compare the recorded RSL values, and check whether the RSL in a certain spectrum is abnormal if the received frequency is within the permitted range.
3-Use a spectrum analyzer to analyze the interference source.
4-Contact the spectrum management department to clear the interference spectrum or change plans to reduce the interference.

There are many methods, you can right click and choose an option about the link. You should check the hedex.