Route mapping for S9712

Sergio93 · Created Sep 8, 2018 06:43:39

Hi,

You can configure some traffic policies and apply them on the switch interfaces :
1) configure ACL to match your subnets :
[Switch] acl 3000
[Switch-acl-3000] rule permit source 192.168.1.0 0.0.0.255
[Switch-acl-3000] quit

2)configure the classifier of the traffic :
[Switch] traffic classifier c1 operator and
[Switch-classifier-c1] if-match acl 2000
[Switch-classifier-c1] quit

3)configure the behavior for the classified traffic:
[Switch] traffic behavior b1
[Switch-behavior-b1]redirect ip-nexthop 10.0.0.1

If multiple next hop IP addresses are configured, the device redirects packets in active/standby mode. A maximum of four next hop IP addresses can be configured in a traffic behavior. The device determines the primary path and backup paths according to the sequence in which next hop IP addresses were configured. The next hop IP address that was configured first has the highest priority and this next hop is used as the primary path. Other next hops are used as backup paths. When the primary link becomes Down, a next hop with higher priority is used as the primary link.

4)configure the traffic policy that we'll be applied later on interface :
[Switch] traffic policy p1
[Switch-trafficpolicy-p1] classifier c1 behavior b1
[Switch-trafficpolicy-p1] quit

5)apply the traffic policy on interfaces(physical or logical)
[Switch] interface gigabitethernet 1/0/1
[Switch-GigabitEthernet1/0/1] traffic-policy p1 inbound
[Switch-GigabitEthernet1/0/1] quit

Hope this helps you.

Route mapping for S9712

Third Party’s Trade Secret

My Followers

Enterprise

Consumer

Corporate

Carriers

Route mapping for S9712

Third Party’s Trade Secret

My Followers