Hi, there.
This procedure was designed to see as graphically as possible, the realization of the configuration file of a NodeB from the configuration file of any other NodeB already integrated with the network.
The following document is designed for a configuration file with the following specifications:
<spec:fileHeader fileFormatVersion="1.1.0" metrology="met" nenrmversion="UMTSDATAV200R015C00A260" neversion="BTS3900 V100R008C00SPC260" producttype="14" syntype="synall"/>
For the realization of a configuration file, it is necessary to have the following data:
-Configuration file of a NodeB model
-Node Name
-IP Address NodeB (Management / Service)
-Subnet Mask (Management / Service)
-IP Address Gateway (Management / Service)
-VLAN ID (Management / Service)
-IP Address Service control card in Controller (GOU)
-Node integration engineering (DataFill).
The parameters to be edited within a model configuration file are defined below.
In steps 2,3,5,6,7,8,11,12, the <SN> field must also be defined, which corresponds to the BBU position of the controller card.
The <SN> field must also be defined, which corresponds to the BBU position of the controller card.
The <SN> field must also be defined, which corresponds to the BBU position of the controller card.
The <SN> field must also be defined, which corresponds to the BBU position of the controller card.
The <SN> field must also be defined, which corresponds to the BBU position of the controller card.
The <SN> field must also be defined, which corresponds to the BBU position of the controller card.
The <SN> field must also be defined, which corresponds to the BBU position of the controller card.
The <SN> field must also be defined, which corresponds to the BBU position of the controller card.
The <SN> field must also be defined, which corresponds to the BBU position of the controller card.
Once the described parameters have been modified, the realization of the configuration file of the new NodeB is terminated. It should be noted that any error in any of these parameters may cause errors such as not obtaining NodeB management, do not lift the NodeB service, unavailable cells, etc. That is why it is recommended to be very careful with the editing of the file, using appropriate compilers for this.
Thanks.
