Radio Resource Management

Latest reply: Jan 14, 2017 10:03:43 1106 1 0 0

Configuring Radio Calibration

  • Radio calibration does not take effect on radios enabled with WDS or Mesh functions.

  • When configuring 40 MHz or 80 MHz calibration bandwidth, check whether channels of the corresponding bandwidth exist under the country code.
  • To ensure a good calibration effect, you are advised to configure at least three calibration channels.
  • When configuring a radio calibration set, avoid using radar channels.

Configuring Load Balancing

The load balancing function applies to scenarios where there is a high degree of overlap between APs' coverage ranges. If APs engaged in load balancing are far from each other, a STA may connect to a distant AP, which affects wireless experience of users.

When the load difference between APs reaches the load difference threshold, some STAs may access the network slowly because the APs will reject access requests of STAs according to the load balancing algorithm. If a STA continues sending association requests to an AP, the AP allows the STA to associate when the number of consecutive association attempts of the STA exceeds the maximum number of rejection times.

In static load balancing mode, APs providing the same services are manually added to a load balancing group. When a STA needs to access a WLAN, it sends an Association Request packet to an AC through an AP. The AC determines whether to permit access from the STA according to a load balancing algorithm. The implementation of static load balancing must meet the following conditions.
  • If dual-band APs are used, traffic is load balanced among APs working on the same frequency band.
  • Each load balancing group supports a maximum of 16 AP radios.

Configuring Band Steering

  • To allow an STA to preferentially associate with the 5 GHz radio and achieve a better access effect, configure larger power for the 5 GHz radio than the 2.4 GHz radio.
  • Single-radio devices do not support the band steering function.
  • The AP2010DN does not support the band steering function.

Configuring Dynamic EDCA Parameter Adjustment

The AP3010DN-AGN, AP5010DN-AGN, AP5010SN-GN, and AP6310SN-GN do not supprot this function.

Configuring Automatic Per Packet Power Adjustment

The AP7030DE and AP9330DN do not support this function.

Configuring the Smart Antenna Function

  • Models supporting smart antenna: AP7030DE and AP7050DE.
  • The smart antenna function cannot take effect if beamforming or MU-MIMO has been configured.

  • x
  • convention:

Mr_xyz
Created Jan 14, 2017 10:03:43 Helpful(0) Helpful(0)

thanks
  • x
  • convention:

Reply

Reply
You need to log in to reply to the post Login | Register

Notice Notice: To protect the legitimate rights and interests of you, the community, and third parties, do not release content that may bring legal risks to all parties, including but are not limited to the following:
  • Politically sensitive content
  • Content concerning pornography, gambling, and drug abuse
  • Content that may disclose or infringe upon others ' commercial secrets, intellectual properties, including trade marks, copyrights, and patents, and personal privacy
Do not share your account and password with others. All operations performed using your account will be regarded as your own actions and all consequences arising therefrom will be borne by you. For details, see " Privacy."
If the attachment button is not available, update the Adobe Flash Player to the latest version!
Login and enjoy all the member benefits

Login and enjoy all the member benefits

Login