[Q&A]Why you save the configuration of device failed on U2000? Highlighted

Finn92 · Created Oct 18, 2018 08:42:29

Thank you very much for your post. Hope you can update continue like this , thank you very much .

we should notice the principle :

The principle of U2000 save configuration of device is that U2000 telnet/stelnet to device without inputing any username or password, and then deploy the save command to device.

This post was last edited by Finn92 at 2018-10-31 08:29.

faysalji · Created Oct 18, 2018 08:42:53

Thanks for sharing with screenshots

littlestone · Created Oct 18, 2018 10:56:18

its so great
I am very interested for this sharing , which is very helpful to our daily work. I have the similar problems in my daily troubleshooting, but I do not know how to deal with them. Now I have a clear idea. Thank you very much for your post. Hope you can update continue like this , thank you very much

Torrent · Created Oct 19, 2018 01:01:39

When you want to save the configuration of device on U2000, you need to add the device first, and then perform save operation.

The principle of U2000 save configuration of device is that U2000 telnet/stelnet to device without inputing any username or password, and then deploy the save command to device.

So we need to make sure that the U2000 can auto telnet or stelnet to devcie.

thanks for sharing us such a good example. [Q&A]Why you save the configuration of device failed on U2000?-2781075-1

This post was last edited by Torrent at 2018-10-31 07:11.

yjhd · Created Oct 19, 2018 01:28:50

thanks for your sharing

No.9527 · Created Oct 19, 2018 06:30:18

Choose Maintenance > System Maintenance > Alarm & Event > Active Alarm to access the Active Alarm page, as shown in Figure 1.
Set Severity, Time, AP Name, AP MAC, IP Address, and Keyword to search for specified alarms.
Click Clear to clear all alarm information.
Click How to Obtain the Alarm Reference? to check how to obtain the Alarm Reference. This post was last edited by No.9527 at 2018-10-31 06:38.

SupperRobin · Created Oct 19, 2018 09:23:41

running the startup saved-configuration command.
Run the display saved-configuration last command to check the system configurations saved last time in the configuration file loaded during the current startup.
Run the display saved-configuration time command to check the last time when the system configurations are saved.
The command output is relevant to user configuration. The command does not display the default configuration. This post was last edited by SupperRobin at 2018-10-31 06:53.

littlestone · Created Oct 23, 2018 05:40:28

This is a great article, I am interested in this article, which is very helpful for our daily troubleshooting. I always have similar problems in my daily work, but I don't know how to deal with them. Now I have a definite idea. Thank you very much for sharing. Hopefully you can update to continue like this

GongXiaochuan · Created Oct 27, 2018 06:17:50

also need configure the protocol for transfer files

This post was last edited by GongXiaochuan at 2018-10-30 06:10.

[Q&A]Why you save the configuration of device failed on U2000? Highlighted

This article contains more resources

Third Party’s Trade Secret

My Followers

Enterprise

Consumer

Corporate

Carriers

[Q&A]Why you save the configuration of device failed on U2000? Highlighted

This article contains more resources

Third Party’s Trade Secret

My Followers