A:
This topic describes how to set the basic alarm and event parameters of the MA5633. You can set the alarm and event parameters flexibly to facilitate the device management and maintenance.
Specifications
To set the basic alarm parameters, run the following commands:
- Run the alarm active clear command to delete the alarms that are not cleared in the system.
- Run the alarm alarmlevel command to set the alarm level.
- Run the alarm jitter-proof command to enable/disable the alarm jitter-proof function and set the alarm jitter-proof period.
- Run the alarm output command to set the output mode of the alarm on the CLI.
To set the basic event parameters, run the following commands:
- Run the event eventlevel command to set the event level.
- Run the event output command to set the output mode of the event on the CLI.
