Hello
I am new to Huawei device. This is my first purchased device (S5720S-52P-PWR-LI-AC) which I received today. When I turn the switch on and start to learn configuration as I normally use Cisco. Progress is slow but pregressing. When I come to POE, it never power up my Camera and AP. The 2 PD I tried to power us required 15W (af type).
I also found the PWR LED indicator is in Amber / orange colour. Since all configuration look normal. I am not sure the meaning of Amber colour in PWR LED.
Your help are much appreciated.
Below are some information for reference:
[SW1]display power
Info: There is no power information.
[SW1]display poe information
PSE Information of slot 0:
User Set Max Power(mW) : 369600
PoE Power Supply(mW) : 369600
Available Total Power(mW) : 369600
Total Power Consumption(mW): 0
Power Peak Value(mW) : 0
Power-Management Mode : manual
Power High Inrush : disable
interface GigabitEthernet0/0/12
description WIFI-PUBLIC AP
port link-type access
port default vlan 201
poe priority high
#
[SW1]display poe power-state interface GigabitEthernet 0/0/12
Legacy detect : disable
Power enable state : enable
Power fast-on state : -
Single-class state : disable
Power-up mode : at
Power-on delay(s) : 0
Power ON/OFF : off
Power status : Detecting
PD class : -
Reference power(mW) : -
Power priority : High
Max power(mW) : 30000
Current power(mW) : 0
Peak power(mW) : 0
Average power(mW) : 0
Current(mA) : 0
Voltage(V) : 0
[SW1]display poe power interface GigabitEthernet 0/0/12
PD power(mW) : 0
PD class : -
PD reference power(mW) : -
User set max power(mW) : 30000
PD peak power(mW) : 0
PD average power(mW) : 0