Pon redundancy

Hello, friend!

To configure Type B single-homing, perform the following steps:

1. Run the protect-group command to create a protection group for xPON access ports.

Note:

a. Set protect-target to gpon-uni-port when GPON Type B single-homing protection is configured.

b. The working mode of the members in the protection group can only be timedelay.

2. Run the protect-group member command to add a protection member to the protection group.

3. Run the protect-group enable command to enable the protection group.

A created protection group is disabled by default. Enable the protection group to make the protection group take effect.

4. Run the display protect-group command to query the information about the protection group and all the members in the protection group.

5. Bind a PPPoE single MAC address pool to a protection group if PPPoE single MAC is enabled.

• To do so, run the bind mac-pool single-mac command in the protect-group mode.

• Otherwise, the PPPoE service carried over the xPON port is interrupted when a protection switchover is performed. In this case, users need to dial numbers up again to go online and the service interruption time is based on BRAS configurations. This may fail to meet the switchover performance requirements of no longer than 50 ms for a protection switchover.

Thanks!