OSN 9800 M24 Service create

Dear friend,

You can configure it through the Navigator.

Run the cfg-add-xc command.

Input Format

Position definition. The number of parameters is 13 and the parameters are unique.

Parameter Position Parameter Value Parameter Remarks

1 Source slot ID

Value range: 1-14, 19

2 Source port number

Value range: depends on the board type.

3 Source channel ID

Value range: depends on the board type.

4. Reserved byte of the source: 0xffff

5 Sink Slot No.

1 - 14, 19

6. Sink port number

Value range: depends on the board type.

7 Sink channel ID

Value range: depends on the board type.

8-sink reserved bytes: 0xffff

9 Service type:

Value range:

any, ge, 10gelan, 10gewan, fe, otu1, otu2, otu3, otu5g, odu0, oduflex, odu1, odu2, odu3, odu4, odu5g, stm1, stm4, stm16, stm64, stm256, oc3, oc12, oc48, oc192, oc768, fc50, fc100, fc200, fc400, fc1000, ficon, ficonex, hdsdi, hdsdi(na), dvbasi, sdi, escon, fddi, sdh5g, isc1g, isc2g, odu0, cbr10g, ibqdr, cpri1, cpri2, cpri3, 10gefc, fc800, 3gsdi, 3gsdi(na),

10 Number of Timeslots Occupied by Oduflex

Value range: determined by the service type.

11 Upper four bytes of the Oduflex rate

Value range: determined by the service type

Lower four bytes of the 12 Oduflex rate

Value range: determined by the service type

13 Oduflex Service Type

ge, 10gelan, 10gewan, fe, otu1, otu2, otu2e, otu3, otu5g, otu3e, otu4, stm1, stm4, stm16, stm64, stm256, oc3, oc12, oc48, oc192, oc768, fc50, fc100, fc200, fc400, fc1000, fc800, ficon, ficonex, hdsdi, 3gsdi, hdsdi(na), 3gsdi(na), dvbasi, sdi, escon, fddi, any, ge(gfp-t), 10gefc, 100gelan, 40ge, ficon4g, ficon8g, etr, clo, isc1g, isc2g, infinibandsdr, infinibandddr, ibqdr, cpri1, cpri2, cpri3, cpri4, cpri5, cpri6, cpri7, cbr10g, ge_ttt_agmp, ficon10g,

Output Format

A success or error message is displayed.

Examples

:cfg-add-dxc:1,1,1,0xffff,2,1,0x2001,0xffff,oduflex,4,0,4267857143,fc400;

Note that the command line is used by professional technical engineers for debugging. Exercise caution when performing this operation.

Good luck!