OSN 3500 1+1 for redundancy

Nino_Chou · Created Jul 25, 2021 09:49:37

Hi friend!

You can insert the spare board into the corresponding slot. The device automatically identifies the slave MPU and does not need to be configured. Note that the software and hardware versions of the newly installed standby main control board must be the same as those of the existing active main control board.

In addition, if the new standby board has been used on other BTSs, that is, if the configuration data of other NEs exists in the board, you need to clear the original data by setting the DIP switch. The active MPU is usually installed in slot 18. You only need to install the standby MPU in slot 17.

Thanks!

Nino_Chou · Created Jul 25, 2021 08:05:17

Hello, friend!
It's nice to meet you in the community.
We're working on getting the right answer for you.

Nino_Chou · Created Jul 25, 2021 09:49:37

Hi friend!

You can insert the spare board into the corresponding slot. The device automatically identifies the slave MPU and does not need to be configured. Note that the software and hardware versions of the newly installed standby main control board must be the same as those of the existing active main control board.

In addition, if the new standby board has been used on other BTSs, that is, if the configuration data of other NEs exists in the board, you need to clear the original data by setting the DIP switch. The active MPU is usually installed in slot 18. You only need to install the standby MPU in slot 17.

Thanks!

Unicef · Created Jul 25, 2021 12:37:47

GOOD ANSWER

OSN 3500 1+1 for redundancy

Best answer

Recommended answer

Third Party’s Trade Secret

`@trans`bright_future`~trans`

My Followers

Enterprise

Consumer

Corporate

Carriers

OSN 3500 1+1 for redundancy

Best answer

Recommended answer

Third Party’s Trade Secret

`@trans`bright_future`~trans`

My Followers