OLT MA5608T send message Last Down Cause (dying-gasp and LOSi / LOBi) to syslog server

Hello, friend!

To upload the last down cause to the Syslog server, run the following command on the MA5608T:

1. Run the syslog alarm-event command to set the function of converting alarms or events into syslogs.

By default, the function of sending events and alarms to the syslog server is disabled. You can run this command to enable the function. If the function of sending events and alarms to the syslog server is enabled, the events and alarms generated in the system are sent to the syslog server. If the function of sending events and alarms to the syslog server is disabled, the events and alarms generated in the system are sent to only the NMS and the command line, which is the existing alarm processing process.

After the function of sending events and alarms to the syslog server is enabled, all the events and alarms are sent to the syslog server.

Note: This command must be executed in privilege mode.

2. Run the syslog sync alarm-event command to send alarms and events to the syslog server one by one in syslog format.

When you need to configure the alarms and events to be sent to the syslog server one by one in the syslog format, run this command.

This synchronization operation conflicts with the operation for synchronizing alarms and traps. That is, the two operation cannot coexist. If the syslog alarm-event is disable, this command cannot be operate successfully.

Thanks!