NG MVPN support in eNSP

Hi

I need to deploy a multicast service over a MPLS-TE running network, im triying to test the NG MVPN funtionalitie but first i would like to simulate it in eNSP. Does anyone knows if the eNSP supports this feature ?

Does anyone trayed it already , i'll apreciate a lot an example on the simulator.

in my test the MVPN tunnel does'nt start

here some captures

[~PE1]dis int Tunnel
Tunnel10 current state : UP (ifindex: 18)
Line protocol current state : UP
Last line protocol up time : 2020-02-19 03:47
Description:
Route Port,The Maximum Transmit Unit is 1500
Internet Address is unnumbered, using address of LoopBack0(11.11.11.11/32)
Encapsulation is TUNNEL, loopback not set
Tunnel destination 33.33.33.33
Tunnel up/down statistics 1
Tunnel ct0 bandwidth is 0 Kbit/sec
Tunnel protocol/transport MPLS/MPLS, ILM is available
primary tunnel id is 0x8041, secondary tunnel id is 0x0
Current system time: 2020-02-19 03:47
    0 seconds output rate 0 bits/sec, 0 packets/sec
    0 seconds output rate 0 bits/sec, 0 packets/sec
    0 packets output,  0 bytes
    0 output error
    0 output drop
    Last 300 seconds input utility rate:  --
    Last 300 seconds output utility rate: --



[~PE1]dis bgp mvpn all peer
 
 BGP local router ID : 172.16.11.2
 Local AS number : 65003
 Total number of peers : 1                 Peers in established state : 1

  Peer            V          AS  MsgRcvd  MsgSent  OutQ  Up/Down       State  PrefRcv
  5.5.5.5         4       65003       11        9     0 00:01:35 Established    
    0
[~PE1]




[~PE1]dis mvpn all-instance ip    
[~PE1]dis mvpn all-instance ipmsi
MVPN local I-PMSI information for VPN-Instance: iptv
Tunnel type: RSVP-TE P2MP LSP
Tunnel state: Down
P2MP ID: 0xb0b0b0b
Tunnel ID: 32769
Extended tunnel ID: 11.11.11.11
Root: 11.11.11.11 (local)
Leaf: None
 

I will apreciate any help, thanks in advance