Figure 1 Flowchart for mounting the eA680-208 on a utility pole without an angle adjusting component
Step 1 Open the SIM card maintenance window of the eA680-208 and insert the SIM card, as shown
in Figure 2.
Figure 2 Installing the SIM card
Notice: When you install the SIM card maintenance window, insert the protrusion into the caging slot to ensure that the SIM card maintenance window is waterproof. Do not fasten the screws until the SIM card maintenance window has been correctly installed.
Step 2 Insert the hose clamp to the wall-mounting frame
Insert the end of the hose clamp that does not contain a screw into the square hole on top of the wall-mounting frame on the back of the unit. When half of the hose clamp passes through the square hole, slightly kink the protruding part and insert it into the other square hole on the front of the unit.
Step 3 Install the hose clamp with the wall-mounting frame on the utility pole, and use a M6 hex key to rotate the screw on the hose clamp to adjust the length of the hose clamp until it is correctly connected, as shown in Figure 3.
Figure 3 Adjusting the length of the hose clamp
Notice:
If the hose clamp is too long, cut off the extra part. Apply anti-rust oil to the cut in case it gets
rusty.
Step 4 Install the installation conversion bracket on the eA680,as shown in Figure 4.
Figure 4 Installing the eA680-208 on the wall-mounting frame
Step 5 Secure the eA680 on the pole-mounting frame through the dovetail groove, Tighten the Mounting Screws Using an M4 Phillips Screwdriver, as shown in Figure 5.
Figure 5 Tightening the screw
You are welcomed to visit our “Enterprise Wireless Information Center” for further document.
http://support.huawei.com/onlinetoolsweb/elte/Info_en.jsp
