MA5800 ring check

Hello, friend!

To configure ring check, perform the following steps:

1. (Option) Run the ring check private-ethtype command to configure the private Ethernet protocol type of ring network detection packets. If the default Ethernet protocol type (0x8300) of ring network detection packets is the same as the existing protocol type on the network, change the protocol type of the ring detection packets to be different from the protocol type on the network.

2. (Option) Run the ring check resume-interval command to set the auto-activation interval for the port in ring check.

After the auto-activation interval is set, when detecting a ring network, the system automatically activates the port that sends the ring check packet.

3. (Option) Run the ring check trap-notify command to set the user-side ring check trap notification mode to alarm.

By default, the user-side ring check trap is notified as an event.

4. Enable the ring network detection.

Run the ring check enable command to enable the user-side ring network detection.

Run the ring check uplink detection enable command to enable the network-side ring network detection.

Run the ring check cascade detection enable command to enable the cascade-side ring network detection.

5. Run the display ring check config command to query the status of the ring network detection.

6. Run the display ring check record command to query the records of the ports, ONTs, or CNUs which were deactivated after ring check is enabled.

Thanks!

Hello my dear friend!

The Ring Check feature enables the device to send the Ring Check packets periodically and monitors the Ring Check packets received on the user-side, cascade-side, and network-side to detect whether a loop occurs on the network of the carrier. If a loop occurs, the MA5800 deactivates the subscriber port on the loop and reports the corresponding alarm to the NMS. This ensures that the device runs in the normal state and that legal users are not affected.

Run the ring check enable command to enable the user-side ring network detection.
Run the ring check uplink detection enable command to enable the network-side ring network detection.
Run the ring check cascade detection enable command to enable the cascade-side ring network detection.

Thanks!