laser MODULE mismatch alarm

yjhd · Created Dec 28, 2018 03:42:06

from N22000, On the NE Panel, double-click a board; alternatively, right-click the board
and choose Path View ==>modify the port , you will found what kind of laser type configured by software

lizhi94 · Created Dec 28, 2018 08:18:06

as you say ：make sure the real physical laser module manufacture information .
2. from U2000, On the NE Panel, double-click a board; alternatively, right-click the board
and choose Path View ==>modify the port , you will found what kind of laser type configured by software
3. if this is diffrent , need delete this port from path view ,it is sure modify port is not work
4. for OTU card ,need need logic fiber // delete cross-connection first
5. after modify laser module ,need put back ccn and logic fiber
it is very useful

Finn92 · Created Dec 29, 2018 02:07:08

if this is diffrent , need delete this port from path view ,it is sure modify port is not work
for OTU card ,need need logic fiber // delete cross-connection first
after modify laser module ,need put back ccn and logic fiber
thank you for sharing .

SupperRobin · Created Dec 29, 2018 03:45:40

1. if this is diffrent , need delete this port from path view ,it is sure modify port is not work
2. for OTU card ,need need logic fiber // delete cross-connection first
3. after modify laser module ,need put back ccn and logic fiber
it is very useful

laser MODULE mismatch alarm

Third Party’s Trade Secret

My Followers

Enterprise

Consumer

Corporate

Carriers

laser MODULE mismatch alarm

Third Party’s Trade Secret

My Followers