This post enquires whether IPv6 is supported for USG5500 simulation on eNSP.
I tried to do the IPv6 interface configuration (ipv6 enable, ipv6 address) on the USG5500 simulation. Afterwards, I ran 'display this' and 'display current-configuration interface g0/0/2' on the CLI.
Neither command showed any output; 'display ipv6 interface brief' commd output was okay, though.
Afterwards, I put in a direct connection between both firewalls simulated USG5500; although both firewalls were wide open ('firewall packet-filter default permit all'), I didn't manage to ping the next hop IPv6 address.
So, I am wondering whether IPv6 is currently supported on the USG firewall simulation?
I was using eNSP version 1.2.00.390.
