An interface generates "bandwidth usage exceeded the log threshold" logs when it goes UP.
The interface Peak rate counters show that traffic is actually within limits.
Interfaces show bandwidth usage exceeded, but traffic counters are within limits
Created: Apr 21, 2017 03:48:30Latest reply: Apr 21, 2017 03:51:09
3433
1
0
0
- x
- convention：
|
Sep 4 2016 19:06:00+02:00 HGKESW01006 %%01IFNET/4/BWRATE_IN_RISING(l)[438523]:Interface input flow bandwidth usage exceeded the log threshold. (Interface=62, BandWidthUsage=100, LogThreshold=80, InterfaceName=GigabitEthernet1/0/6)
Sep 4 2016 19:06:00+02:00 HGKESW01006 %%01IFNET/4/BWRATE_OUT_RISING(l)[438524]:Interface output flow bandwidth usage exceeded the log threshold. (Interface=62, BandWidthUsage=100, LogThreshold=80, InterfaceName=GigabitEthernet1/0/6) Sep 4 2016 19:06:01+02:00 HGKESW01006 %%01IFPDT/4/IF_STATE(l)[438525]:Interface GigabitEthernet1/0/6 has turned into UP state. Sep 4 2016 19:06:06+02:00 HGKESW01006 %%01IFPDT/4/IF_STATE(l)[438528]:Interface GigabitEthernet1/0/6 has turned into DOWN state. Sep 4 2016 19:06:09+02:00 HGKESW01006 %%01IFNET/4/BWRATE_IN_RESUME(l)[438529]:Interface input flow bandwidth usage was restored to the log threshold. (Interface=62, BandWidthUsage=74, LogThreshold=80, InterfaceName=GigabitEthernet1/0/6) Sep 4 2016 19:06:09+02:00 HGKESW01006 %%01IFNET/4/BWRATE_OUT_RESUME(l)[438530]:Interface output flow bandwidth usage was restored to the log threshold. (Interface=62, BandWidthUsage=67, LogThreshold=80, InterfaceName=GigabitEthernet1/0/6)  Handling ProcessThe topology was analyzed and it was revealed there are no forwarding loops. QoS rate limits were configured on the interface, but they did not take effect: qos lr outbound cir 700000 cbs 87500000 Root CauseIt was discovered that the access device connected to the interface was configured with 10Mbps Ethernet speed. The 10Mbps speed was easily exceeded, causing the bandwidth usage logs. %2016-Sep-04 19:06:01.260.1+02:00 01IFPDT/4/DUPLEX_HALF(D)[513406]:Slot=CCC0/0; Interface GigabitEthernet1/0/6 duplex mode log. (PhyStatus=UP, PreDuplex=FULL, CurrDuplex=FULL, Speed=10M, Function=IFPDT_ChangePortStatus, Line=909) SolutionReplace the access device NIC with a NIC capable of higher speeds. |
|
Comment
Notice: To protect the legitimate rights and interests of you, the community, and third parties, do not release content that may bring legal risks to all parties, including but are not limited to the following:- Politically sensitive content
- Content concerning pornography, gambling, and drug abuse
- Content that may disclose or infringe upon others ' commercial secrets, intellectual properties, including trade marks, copyrights, and patents, and personal privacy
