Installation Check of eA680 LTE CPE

After you install the eA680, perform a hardware installation check and a power-on check.

Prerequisites

The eA680-208 hardware has been installed.

Procedure

Step 1: Check whether the eA680 hardware is correctly installed.

When performing the hardware check for the eA680, check the items listed in Table 1 in order.

                     Table 1  Hardware installation check of the eA680

When checking the cable connections of the eA680-208, check the items listed in Table 2 in order.

                         Table 2 Cable connection check of the eA680

Step 2: Perform the power-on check, as shown in Figure 1.

           Figure 1 Power-on check of the eA680

The items listed in Table 3 must be checked during eA680 indicator check.

                              Table 3 Indicator Check

NOTE:If the RSSI indicator is off when the eA680 powers on, the signal strength is too weak. Check the power supply and the angle of the angle adjusting component.

---End

 You are welcomed to visit our “Enterprise Wireless Information Center” for further document.
http://support.huawei.com/onlinetoolsweb/elte/Info_en.jsp