Install VRM hangs at 99% for FusionSphere 6.5.1
Created: May 5, 2020 08:04:45Latest reply: Jun 12, 2020 23:40:41
476
8
0
0
0
Rewarded HiCoins：
1
(problem resolved)
- x
- convention：
- Emotion(0)
Featured Answers
sysadmin_by
Created May 6, 2020 08:07:21
(0)
(0)
Hello! Thanks for reply! 1. Host OS was fresh-installed FusionOS 6.5.1 1a. OS on management notebook is quite good, but maybe there are sme recommendations or best practices for it? Version, name,JRE versions, etc? 2. Fully decompressed. But maybe there are some advices to check if everything is in place? Some files? 3. No VLANs used. Network is good enough and is setup correctly. 
|
All Answers
sysadmin_by
Created May 5, 2020 08:29:19
(0)
(0)
There are NO error messages. However, I found this 5-year old post: https://forum.huawei.com/enterprise/en/not-able-to-install-vrm/thread/242351-893 Maybe this is my case, but the same as for author of that post - my write and read policies are default and were not changed. Moreover, 9-hour-long installation is... at least a bit strange. |
sysadmin_by
Created May 6, 2020 08:07:21
(0)
(0)
Hello! Thanks for reply! 1. Host OS was fresh-installed FusionOS 6.5.1 1a. OS on management notebook is quite good, but maybe there are sme recommendations or best practices for it? Version, name,JRE versions, etc? 2. Fully decompressed. But maybe there are some advices to check if everything is in place? Some files? 3. No VLANs used. Network is good enough and is setup correctly.
|
Comment
Notice: To protect the legitimate rights and interests of you, the community, and third parties, do not release content that may bring legal risks to all parties, including but are not limited to the following:
- Politically sensitive content
- Content concerning pornography, gambling, and drug abuse
- Content that may disclose or infringe upon others ' commercial secrets, intellectual properties, including trade marks, copyrights, and patents, and personal privacy
