Hi there!
This section describes how to insert SC/PC fiber connectors.
Prerequisites
The end face of the fiber must be clean.
Wear an ESD wrist strap before carrying out this operation.
Tools, Instruments, and Materials
None
Precautions
DANGER:
Laser is dangerous. The light is not visible to the eyes with or without laser protective glasses. Do not look into optical connectors or ports. Failure to follow this warning can cause damage to the eyes or even blindness.
NOTICE:
Wear a well-grounded ESD wrist strap whenever you touch any equipment or board. Make sure that the wrist strap fully touches your skin. Insert the connector of the ESD strap into the ESD socket in the subrack.
Procedure
1. Remove the protective cap on the SC/PC connector.
2. Align the keyed ridge on the SC/PC fiber connector with the concave slot of the optical port.
3. Push the connector in with proper force. After the connector is seated properly, the keyed ridge shall match the concave slot.
4. The fiber is not seated properly until it clicks.
That's all, I welcome everyone to leave a message and exchange in the comment area!
Thank you！
