Initialize the admin password

Hi Lucas,

Perform the following steps to initialize the admin password:

1.    Log in to the device by using _super_admin through the serial port. The default password of _super_admin is Admin@revive.

2.    Run the initpasswd command to initialize the admin password on the CLI. This command will initialize the admin passwords of controllers A and B to Admin@storage.

3.    Use the admin account and Admin@storage password to log in to the device on the CLI. Run the chguserpwd command to change the password of the admin account.

You can enter Admin@storage for initializing the password or set a new password.

Thanks.