Huawei Mobile Wifi E5573 Flashing Green Lights After Factory Reset

Hello,

Dear friend!

The default access IP address is 192.168.8.1 

Username and password use "admin" both must be in lower case alphabets.

To restore the device to its factory settings, power on the device, find the hardware restore button on the device, and press and hold the button for about 5 seconds to restore the device to its factory settings. Then, use the default password to enter the home screen again. If the operation fails, please contact your device vendor to check whether the hardware is damaged.

Thanks

Hi friend.

The E5573 is a consumer product. This forum is aimed at enterprise network products.

To perform a factory reset, follow these steps.

• Power on the Huawei router and insert the paper clip or pin into the hole labeled "Reset" on the back of the router.

• Press and hold the paper clip or pin for 10 to 15 seconds and release it.

• The router will reboot itself. Once the WLAN light stops blinking, the router resets.

• Note that resetting the Huawei router will not reset the firmware to an earlier version. It will only change all settings back to factory defaults.

If the device still fails to be reset, the device hardware may be faulty. You are advised to contact your local ISP for troubleshooting.

I hope I can help you.

Hello, friend!

Based on the problem description and the information you provided, the initial abnormal state of the device was due to the device entering upgrade mode. However, the reset operation causes the device to fail to be upgraded and enters the abnormal state of repeated upgrades.

I am sorry, I can't operate the device in online mode. You need to take the device to a local Huawei outlet. You need to forcibly upgrade the device to restore its normal state.

Thanks!