Huawei honour Router 2S settings

Huawei honour Router 2S is an upgraded version of 2. It mainly adds 4 signal amplifiers. Its function is to increase wireless coverage and wall-crossing capability. It further optimizes the quality of WiFi signal and costs 20 yuan. If you have requirements for the intensity of WiFi signal, you can buy this one. Today we mainly talk about how to set up a new router for honour Router 2s, in fact, with Router 2. The settings are the same, not much different.
1. Similarly, plug the router into the power supply first, and connect the outlet behind the router with the light cat's LAN port with the network cable. Any one of the three outlets at the router's end is possible.
2. We use mobile phones to connect the default WiFi of honour 2S router, which usually starts with HUAWEI and has the strongest signal and no password. It can be set without a computer.
3. After the mobile phone connects to the default WiFi of the router, open the browser address bar on the mobile phone and enter 192.168.3.1. It goes into the interface like the figure below. We Click to start the experience.
4.honour 2S router is very intelligent, it will automatically detect your way of surfing the Internet. If you are newly installed broadband, it is usually the way to automatically acquire dynamic ip. This way does not need any settings, but if it is the result of the previous installation of broadband test may be dial-up mode of surfing the Internet.
5. Then we will go to the interface below and ask for broadband account and password. When this operator is installed, it is usually written on the payment list. You can find it, but you can't find the customer service telephone request for the operator.
6. Click on the next step to the WiFi settings interface. The default is that the dual-band selection is equivalent to one. The default is OK. The WiFi name and the WiFi password should be filled in according to your preference. But you must remember the WiFi password because the default is the same as the login password. You'd better write it on paper.
7. Point to the following interface after the next step, default check to restore the factory to retain the key configuration, this function is good, later restore the factory without filling in the above settings, default selected through the wall mode, default on the line.
8. Continue to click on the next step, and you will see that the router will restart. After success, you can connect your mobile phone to the newly set WiFi and enter the WiFi password to get online.
9. If you want to enter the router settings interface later, you only need the mobile phone to connect to WiFi and enter 192.168.3.1 in the browser. Then you can enter the WiFi password and log in. Then you can see the status of the router and other settings.