Hello everyone,
This post is regarding Huawei eNSP & Cisco GNS3 mixing experiment
While experimenting with a mixture of Cisco and Huawei devices using GNS3 and eNSP simulators, the main idea is to use both emulators to communicate with real computers
The setup on GNS3 is shown in the topology diagram below:
The router console port on GNS3 started in 2001 and the eNSP console port started in 2000. You can change the eNSP console port number.
On eNSP, the topology is shown.
On device ar1220-ar0, the console port number was changed to 2002 and the e0/0/0 port was bound to VMnet1. Set the console port of device ar1220-ar1 to 2003.
Turn on all devices once the configuration is done,n configure the IP address and host name on the GNS3 device.
On the eNSP device RT1:
On eNSP device RT2:
GNS3 communicates with eNSP:
We configured rip:
That is all I want to share with you! Thank you!
