HRP error
Created: Oct 24, 2019 14:06:52Latest reply: Oct 24, 2019 14:12:18
520
1
0
0
0
Rewarded HiCoins：
0
(problem resolved)
As shown in the topy, the two firewalls establish OSPF neighbors with the routers. However, when the HRP is enabled on the firewalls, the OSPF neighbor of FW3 is down and can’t ping AR6, and the peer end cannot be pinged, The following is the HRP configuration. Please help me to see what the problem is. Thank you.
hrp enable
hrp mirror config enable
hrp interface GigabitEthernet1/0/0 remote 10.0.12.2
hrp mirror session enable
hrp nat resource primary-group
hrp preempt delay 300
- x
- convention：
- Emotion(0)
Featured Answers
|
Hi Sprout,
The hrp mirror config enable command is used to enable the mirroring mode. By default, only the MGMT interface and theheartbeat interface of the standby device can receive or send packets. So you need to cancel this command. https://support.huawei.com/hedex/hdx.do?docid=EDOC1100068394&id=sec_admin_hotstandby_0019&text=null&lang=en  |
|
All Answers
|
Hi Sprout,
The hrp mirror config enable command is used to enable the mirroring mode. By default, only the MGMT interface and theheartbeat interface of the standby device can receive or send packets. So you need to cancel this command. https://support.huawei.com/hedex/hdx.do?docid=EDOC1100068394&id=sec_admin_hotstandby_0019&text=null&lang=en |
|
Comment
Notice: To protect the legitimate rights and interests of you, the community, and third parties, do not release content that may bring legal risks to all parties, including but are not limited to the following:
- Politically sensitive content
- Content concerning pornography, gambling, and drug abuse
- Content that may disclose or infringe upon others ' commercial secrets, intellectual properties, including trade marks, copyrights, and patents, and personal privacy
