Hi, guys!
Good day to you!
This topic describes how to setup a TE80 (Enable web configuration function)
Issue Description
Cannot access the web administrative interface, the page is not loading even if the internet connectivity is up between the source host and terminal.
Model and firmware of the device:
Solution
TE80 has the web configuration function disabled in the factory default settings, meaning that if you cannot access its web administrative interface until you enable it. Here is the proper way in activating the web function for a TEX0 (TE30/40/50/60/80).
Here are the steps for a proper configuration and activation of the web administrative function in order to be able to log in to the device's web GUI.
1. Connect to the codec in SSH mode.
Run the web set on command to enable the web configuration function. This function is disabled in the codec's factory default settings.
The default SSH user name and password are debug and Change_Me, respectively.
2. After the above step you can successfully log in to the codec web interface using the user name admin and password Change_Me (default credentials).
Thanks for reading!
