Model and firmware of the device:
Cannot access the web administrative interface, the page is not loading even if the internet connectivity is up between the source host and terminal.
How to setup a TE80 codec properly (enable web configuration function)
Created: Apr 10, 2017 10:00:53Latest reply: Jun 7, 2018 08:36:38
1565
2
0
0
0
- x
- convention：
- Emotion(0)
|
TE80 has the web configuration function disabled in the factory default settings, meaning that if you cannot access its web administrative interface until you enable it. Here is the proper way in activating the web function for a TEX0 (TE30/40/50/60/80). Here are the steps for a proper configuration and activation of the web administrative function in order to be able to log in to the device's web GUI. 1. Connect to the codec in SSH mode. Run the web set on command to enable the web configuration function. This function is disabled in the codec's factory default settings. The default SSH user name and password are debug and Change_Me, respectively.
2. After the above step you can successfuly log in to the codec web interface using the user name admin and password Change_Me (default credentials):
|
|
Comment
Notice: To protect the legitimate rights and interests of you, the community, and third parties, do not release content that may bring legal risks to all parties, including but are not limited to the following:
- Politically sensitive content
- Content concerning pornography, gambling, and drug abuse
- Content that may disclose or infringe upon others ' commercial secrets, intellectual properties, including trade marks, copyrights, and patents, and personal privacy
